Engine parts & Cooling parts

Reconditioned parts

From stock on exchange basis only

Cylinderhead 1494, 1592, 1725 (Alu, Cast Iron)

Short engines (1494, 1592, 1725)

Diff unit (3.89-4.22)

Gearbox (3 synchro, 4 synchro, overdrive A type, D type)

Now new in stock

Engine mounts Minx, Rapier series 1-2

2.5 cm high

Made with the correct rubber compound. Not too soft, not too hard. You will notice direct the difference in engine vibration !!!

Price 19,50 + VAT

2.5 cm high

Engine mounts FOR

Hillman S. Minx MK1 Humber Vogue (Austr.)

4.5cm high

Made with the correct rubber compound. Not too soft, not too hard.

Oil resistant.

You will notice direct the difference in engine vibration !!!

Price 19,50 + VAT

4.5cm high

New Camshafts for the 1494 and 1592 Alu head engines

Only € 179,50 !

Allways replace camfollowers when rebuilding your engine!

Camshafts for the 1725 Alu head engines

Only € 169,50 !

Oilpump repair set 5220340

for our 1592 engines.

Rotor, vane and hardened shaft

Offer price € 59.50 +VAT

For series 2-4

Camfollowers for 1390, 1494, 1592 and 1725 Alu head engines

Offer price € 9.50 +VAT

Rear wheel bearings

Original specs ! 9188096 Bearing Rear axle shaft 1390, 1494, 1592 P.43652

Now new in stock

Price € 47.50 +VAT

1801176 Wheelbearing & seal 1725 (75221451)

Original specs ! C3 bearing

Now new in stock

Price € 49.50 +VAT

Rocker- shaft (pair)

Avaliable for alu and cast iron head (1390-1725cc)

Now new in stock

Price € 69.50 +VAT

Main bearing set 1956-1967 (1390, 1494 and 1592)

STD, 010", 020" and 030" for the 1390, 1494 and 1592 Sunbeam, Hillman, Singer and Humber 4 cylinder engines..

Offer price € 59.50 +VAT

For series 1-4

Big end bearing sets 1592 cc and 1494 cc

STD, 010", 020" and 030" for the 1494 and 1592 Sunbeam, Hillman, Singer and Humber 4 cylinder engines.

Offer price € 59.50 +VAT

Please state for 1494 cc or 1592 cc

Main bearing set 1967- (1725)

For the 1725 Sunbeam, Hillman, Singer and Humber 4 cylinder engines..

Offer price STD, 010", € 69.50 +VAT

020" and 030" and 040 € 39.50 +VAT.

Some 050 and 060 available at request

Big end bearing sets 1725 cc

STD, 010", 020" and 030" for the 1725 Sunbeam, Hillman, Singer and Humber 4 cylinder engines.

Offer price STD, 010", € 69.50 +VAT

020" and 030" and 040 € 39.50 +VAT.

050 and 060 available at request

Original water pumps

For all 1592 and 1725 cc engines.

Designed for better flow and uprated pressure.

Cast iron creates less corrosion.

Height approx 130mm

Price € 72.50 +VAT outright !

Height approx 130mm

Original water pump 1390 and 1494 cc engines

For all 1390 and 1494 cc engines, now in stock again!!

Designed for better flow and uprated pressure.

Cast iron creates less corrosion.

Height approx 100 mm

Price € 79.50 +VAT

Height 85 mm

NEW

Waterpump repair kit:

Early models 1948-54 Side valve

This kit comprises new bearing, impeller and seal

Some parts in stock for side valve engines

Price €79.50+VAT

Waterpump repair kit:

1955-61 OHV 1390/1494

This kit comprises bearing and seal

Please state model/serie when ordering !!!

Price €39.50+VAT

NEW

Waterpump Impellor

4 Cylinder petrol OHV 1955-60

4 Cylinder petrol OHV 1961-68 1592/1725

40 € plus VATPlease state model (series) when ordering !!!

Thermostat cover

Thermostat Housing Cover

Pressure die cast!

Late 1592 and 1725 aluminium head models

€ 34,50 + VAT

NEW

1208229 Water outletpipe / Thermostat cover

Thermostat Housing Cover

Pressure die cast!

Early 1592 models

Offer price € 34.50 +VAT

Thermostat housing 1963 onwards

Complete with gaskets

Offer price 59.50€

Starterring gear

Made by an original supplier.

Avaliable for all 1390, 1494, 1592 and 1725 engined cars.

€ 69.95 plus VAT

Crankshaft Pulley (excl damper)

High quality remake of the original "Metalastic" type pulleys fitted form 1956 onwards on for Aluminium head engines only

Lightweight (LM13) & pre balanced.

Price € 89,50 + VAT

Door handle, outer front (only)

(handed; in pairs)

Assembled, you use your own set of barrels and keys

Price per pair: € 165+VAT

New Hornring

Humber Sceptre MK2

Rapier series 4-5

99.50€

Box is shown for display purposes only).

Electronic and standard distributors

Distributors for 1600 and 1725 alium head engines.

This is a late 45D4 Lucas type version, specially made for us.

Both versions avaliable for Alu and Cast Iron head cars !

The electronic version Neg earth car only !

45DE4 Electronic 195€ plus vat

Buy now 149,50€

45D4 standard version 140€ plus VAT

Buy now 99€

Contact breaker less version 45DE4

Below the standard model

Steering and suspension

New! Center steering rod 5220976 (QDL990)

Now again available in limited supply: The center steering rod with ball joints and grease nipples like the original Rootes part.

The rubber bushed model was introduced in the 60's as cheaper to produce part removing grease points.

This is the ultimate replacement part for your car. No sloppy, in secure steering anymore!!

Price € 79.50+VAT

Offer price 69.50€ +VAT

Shock absorbers

Monroe Front shock-absorbers for Superminx, Vogue, Sceptre 1961-65 and later Minx Gazelle, Rapier Venezia

Price € 179.50+VAT

Offer price 129.50€ +VAT

Rear shock-absorbers for Superminx, Vogue, Sceptre 1961-65

Venezia

Price € 179.50+VAT

Offer price 129.50€ +VAT

SPAX adjustable front shock-absorbers for

Hillman Minx 1-3c

Sunbeam Rapier 1-3

Singer Gazelle 1-3c

Hillman Husky 1-3

Commer Van 1-3

(please forward chassisnumber)

Price € 179.50+VAT

Offer price 129.50€ +VAT

Rear shock-absorbers for Minx, Rapier and Gazelle Husky

Series 3 onwards (please forward chassisnumber)

Price € 179.50+VAT

Offer price 129.50€ +VAT

Fulcrum pin silent bushes

Original "Metalastic" type

Metal bonded bushes.

Proper fit, give back that original ride to your car!

Quantity per side: 2

Top fulcrum bush (each) Price €11.25 +VAT

Lower fulcrum bush (each) Price € 13.50 +VAT

NEW Top fulcrum pin and bush set 1961-

1224225

Pin c/w rings and nuts, bush separate availiable

€ 69,50 plus vat

NEW Bottom fulcrum pin and bush set 1961-

1224224

Pin c/w rings and nuts, bush separate avaliable

€79,50 plus vat

Relay lever pin (remote steering lever)

All Alpines 1959-67

Offer price 45 € +VAT

a K.24275 Bush, steering only is 8.25 € +VAT

Relay lever repair kit 1955-1967

(in picture part 6)

Replacement steering idler pin as original Rootes part in design and quality.

Kit includes 2 bushes

Kingpin set P.48890

Sunbeam Alpine 1-3 Sunbeam Rapier 1-4 Hillman Minx 1-4 Singer Gazelle 1-3 Commer Cob

Price € 49.50 per side+VAT

Track rod ends

1 Pair:

Left-hand & right-hand thread

Alpine all models 1959-

Offer price € 42.50+VAT

Track rod shaft

1956-1967 Sunbeam Rapier 1-4 Hillman Minx 1-4 Singer Gazelle 1-3 Commer Cob, Superminx, Vogue, Sceptre 1961-65

Venezia

This is the shaft that connects the 2 balljoints.

It comes including the 2 special nuts (left hand / right hand thread) Price € 21.50+VAT Offer price 17.50€ +VAT

Price excludes the balljoints !

Top fulcrum pin and bush set (P.48612)

Sunbeam Alpine 1-3 Sunbeam Rapier 1-4 Hillman Minx 1-4 Singer Gazelle 1-3 Commer Cob

Price per side € 69.50+VAT

Lower fulcrum pin and bush set (P.48610)

Sunbeam Alpine 1-3 Sunbeam Rapier 1-4 Hillman Minx 1-4 Singer Gazelle 1-3 Commer Cob

Price per side

€ 79.50+VAT

P108345/P108341 Lower Eyebolt and Bush Outer series I - III

Sunbeam Alpine 1-3 Sunbeam Rapier 1-4 Hillman Minx 1-4 Singer Gazelle 1-3 Commer Cob

Outer lower fulcrum pin and bush set

Price per side € 29,50+VAT

Bump stop

front suspension

Superminx, Vogue, Sceptre 1961-65, Venezia, Minx series

Top (1214933 p.100587)

Bottom (1207804 1216035) pan

Original design & UNF thread

Price

Top € 9.50+VAT

Bottom € 12.00 + vat

Ball joint (Bottom) 1963-

Humber Sceptre, Hillman Super Minx, Singer Vogue

Minx, Gazelle, Commer Cob, Husky

Price € 67.50+VAT Offer price 52.50€ +VAT

Ball joint (Top) 1963-

Humber Sceptre, Hillman Super Minx, Singer Vogue

Minx, Gazelle, Commer Cob, Husky

Price € 45+VAT Offer price 42.50€ +VAT

Top ball-joints for:

1223762 Ball Joint Upper '59-61

Sunbeam Alpine 1-3

Hillman Minx 1-3c

Sunbeam Rapier 1-3

Singer Gazelle 1-3c

Hillman Husky 1-3

Commer Van 1-3

Price € 65+VAT Offer price 49.50€ +VAT

Rear suspension

Rear spring front bush, large offset

9188167

Price € 16+VAT

Rear spring rear bush,

9188018

Price € 9.50+VAT

Gearbox parts

Layshaft Gearbox

Covers all models 1952-76. Except Imp, Avenger and 6 cylinder Humber

Price € 34.75+VAT

Bush rear cover

std gearbox

5220886

New! Engine mounts Rapier 1-2 2.5 cm high Made with the correct rubber compound. Not too soft, not too hard. You will notice direct the difference in engine vibration !!! Price € 19,50 + VAT
New! Engine mounts Hillman S. Minx MK1 Humber Vogue (Austr.) 4.5cm high Made with the correct rubber compound. Not too soft, not too hard. Oil resistant. You will notice direct the difference in engine vibration !!! Price € 19,50 + VAT